Skip to content

Power Steering Pump and Rack & Pinion Cardone

Power Steering Pumps and Rack & Pinion Warranty Guidelines

Royal Flush – Recommended Flush Procedure

Prior to replacing any power steering system component, the power steering system must be flushed before operation. Flushing removes old hydraulic fluid and contaminants in the power steering system that will cause accelerated wear or improper operation of the replacement unit. Follow the steps below to properly flush the system.

  1. Remove pressure and return lines from pump. Flush pump reservoir, return and pressure lines by pouring new fluid through components until fluid runs clear. Be sure to only use fluid recommended for your vehicle.
  2. Reconnect pressure line to pump and steering component. Reconnect return line only to steering component.
  3. Place return line from power steering unit into a drain pan. Cap return port on reservoir to prevent leakage.
  4. Fill power steering pump reservoir with NEW fluid recommended for your vehicle.
  5. Disable the engine so it will not start when cranked: Refer to vehicle service manual for correct procedure.
  6. Crank engine and continue to replenish fluid until fluid coming from return line has no air bubbles. NEVER LET THE POWER STEERING PUMP RUN DRY! Note. Do not crank engine for more than a few seconds at a time or starter will overheat.
  7. Install an in-line power steering fitter in return line to increase the life of the power steering components. Connect the return line.
  8. to the power steering pump, making sure all lines are properly torqued. Overtightening hydraulic lines will strip the threads. Failure to install a filter or properly torque fittings will Void WARRANTY.
  9. Be sure fluid in pump reservoir is at proper operating level.
  10. Start the engine and turn the steering wheel from side to side 2 to 4 times to bleed the system.
  11. Refill reservoir to proper level if necessary.
  12. Check for smooth assist, excessive noise, connections for leakage and system for proper operation.
A diagram of a power steering system Description automatically generated

-Warranty does not include any damage caused by foreign objects.

-Warranty can only be granted if there are no signs of improper installation (Check above guidelines).

Power Steering Pumps and Rack & Pinions come with a forty-five (45) day Warranty, under the General Warranty Policy, ONLY if Power Steering Pumps and Rack & Pinions Warranty Guidelines are followed.